Kodak 5500 - Manual (Page 64)

A-61074 April 1997 3-43
NOTE: The bar code reader is an accessory which must be installed
and enabled by your Field Engineer.
Bar code reader defines the options required when using the bar
code reader accessory.
•
Select Bar Code Reader from the Mode Configuration window.
Single
6006
3111
Supprs
FthenR
None
Off
Off
NA NA Index Format
IA Field Width
Level Rules
IA Display Format
Adjoining IA
Batching
Length Monitor
Skew Monitor
Footswitch Patch Reader
COIN2 Port Select
OCR
Bar Code Reader
Printr Controller
Front Printer
Rear Printer
Mode Name
Overrides Off
n/a
n/a
Off
Supprs
Off
Off
MODE0
No Sav
Save & End Session
Save & Prev Menu
Don't Save & End Session
Don't Save & Prev Menu
Mode Number: 01 Mode Name: MODE01 Item #: 13.0
Mode Configuration Bar Code Reader
On/Off
Bar Code Type
Codes Per Document
Minimum Code Length
Maximum Code Height
Scan Direction
Code Quality
Confirmation Tone
Bar Code Location
Previous Menu
The following pages provide instructions on how to define the bar
code reader options. When the patch reader definitions are
complete, you will automatically be returned to this window.
To close the Bar Code Reader menu:
•
Select Previous Menu. Proceed to make any additional mode
configuration definitions.
NOTE: If the bar code reader was not defined as Present during
Accessory Configuration, the following message will appear:
The accessory that you requested is not enabled in
Accessory Configuration.
•
Press Enter.
•
Exit from Mode Configuration; refer to the section entitled,
Exiting Mode Configuration.
Contact your Field Engineer to install and enable this accessory.
Bar code reader