Kodak 5500 - Manual (Page 7)

1-4 A-61074 April 1997
Using the Mode Setup
Software Questionnaire
and Instructions
Logout procedure
To select the Previous Menu option:
— Use the arrow keys to position the highlight cursor over the
Previous Menu option or press the Pagedown key to
automatically position the highlight cursor over the
Previous Menu
option.
— Press Enter.
•
If a message is received which indicates that an accessory is not
installed, press
Enter to continue. This message indicates that the
option selected requires an accessory which is not physically
installed and/or properly defined to the software. In either instance,
contact your Kodak service representative to properly install and/or
define the accessory.
•
If a message is received which indicates that a selection is not
available, press
Enter to continue. This message indicates that the
option selected is not available in the mode selected, or for the
machine configuration.
There are two pieces of documentation designed for use with the
Mode Setup Software: the Installation Instructions, which provide
information on how to install, access and use the software to define
the available options; and the Installation Questionnaire, which
provides a convenient form on which to record all of the machine and
mode definitions.
Once you have completed the installation, perform the following
steps to logout of the system.
From the Machine Configuration window:
•
Select End Session to exit to DOS.
or
From the Mode Configuration window:
•
Select Save & End Session if you wish to save all of the definitions
and return to the Configuration Selection window.
•
Select End Session from the Configuration Selection window to
exit to DOS.