Kodak 5500 - Manual (Page 73)

3-52 A-61074 April 1997
Bar code location Bar code location defines whether the bar codes are to be located on
the front or rear of the document(s).
The default for all modes is Front.
The options are:
— Front—the bar code reader attempts to detect bar codes on the
front side of each document.
— Rear—the bar code reader attempts to detect bar codes on the
rear side of each document.
NOTE: This option is only valid when using a duplex Scanner 5500/
7500. Also, if bar codes are located on the side opposite the
side defined as the bar code location, then the bar codes will
not be detected.
•
Select Bar Code Location from the Bar Code Reader menu.
Single
6006
3111
Supprs
FthenR
None
Off
Off
NA NA Index Format
IA Field Width
Level Rules
IA Display Format
Adjoining IA
Batching
Length Monitor
Skew Monitor
Footswitch Patch Reader
COIN2 Port Select
OCR
Bar Code Reader
Printr Controller
Front Printer
Rear Printer
Mode Name
Overrides Off
n/a
n/a
Off
Supprs
Off
Off
MODE0
No Sav
Save & End Session
Save & Prev Menu
Don't Save & End Session
Don't Save & Prev Menu
Mode Number: 01 Mode Name: MODE01 Item #: 13.9
Mode Configuration Bar Code Reader
On/Off
Bar Code Type
Codes Per Document
Minimum Code Length
Maximum Code Height
Scan Direction
Code Quality
Confirmation Tone
Bar Code Location
Previous Menu
Bar Code Location
Front
Rear
Previous Menu
•
Select the side of the document(s) on which bar codes will be
placed.
•
Press Enter.