Kodak 5500 - Manual (Page 78)

A-61074 April 1997 3-57
NOTE: The front printer is an accessory which must be installed and
enabled by your Field Engineer.
Front printer defines the options required when using the front printer
accessory.
•
Select Front Printer from the Mode Configuration window.
Single
6006
3111
Supprs
FthenR
None
Off
Off
NA NA Index Format
IA Field Width
Level Rules
IA Display Format
Adjoining IA
Batching
Length Monitor
Skew Monitor
Footswitch Patch Reader
COIN2 Port Select
OCR
Bar Code Reader
Printr Controller
Front Printer
Rear Printer
Mode Name
Overrides Off
n/a
n/a
Off
Supprs
Off
Off
MODE0
No Sav
Save & End Session
Save & Prev Menu
Don't Save & End Session
Don't Save & Prev Menu
Mode Number: 01 Mode Name: MODE01 Item #: 15.0
Mode Configuration Front Printer
On/Off
Print Definition
Vertical Start Print Position
Previous Menu
The following pages provide instructions on how to define the front
printer options. When the front printer definitions are
complete, you will automatically be returned to the Mode
Configuration window.
To close the Front Printer menu:
•
Select Previous Menu. Proceed to make any additional mode
configuration definitions.
NOTE: If the front printer was not defined as Present during
Accessory Configuration, the following message will appear:
The accessory that you requested is not enabled in
Accessory Configuration.
•
Press Enter to clear the message.
•
Exit from Mode Configuration; refer to the section entitled,
Exiting Mode Configuration.
Contact your Field Engineer to install and enable this accessory.
Front printer