Kenmore 87002 - Manual (Page 17)

16
Anytime in the operation of the oven, when
the oven cavity temperature reaches a
phenomenon of 300°C, the oven automatically
enters into self protection mode with one
beeping every 1.5 sec until the said
phenomenon disappears, and STOP/CANCEL
is pressed to make the oven back to normal.
During grill or combination cooking, when the
temperature of oven cavity is lower then 40°C
after cooking already takes place for 5 minutes,
the oven will automatically enter into
protection mode with the screen displaying
error code E 02. This error may disappear
after you press the CANCEL pad.
Error may also occur to the system sensor,
which will make the oven enter into protection
mode with the screen displaying E 04, and
beeps can be heard. As soon as this
malfunction disappears, press CANCEL, the
oven will back to normal.
CLEANING AND CARE
1. Turn off the oven and remove the power plug from the wall socket before cleaning.
2. Keep the inside of the oven clean. When food splatters or spilled liquids adhere to oven walls,
wipe with a damp cloth. Mild detergent may be used if the oven gets very dirty. Avoid the use
of spray and other harsh cleaners as they may stain, streak or dull the door surface.
3. The outside surfaces should be cleaned with a damp cloth. To prevent damage to the operating
parts inside the oven, water should not be allowed to seep into the ventilation openings.
4. Wipe the door and window on both sides, the door seals and adjacent parts frequently with a
damp cloth to remove any spills or spatters. Do not use abrasive cleaner.
5. Do not allow the control panel to become wet. Clean with a soft, damp cloth. When cleaning
the control panel, leave oven door open to prevent oven from accidentally turning on.
6. If steam accumulates inside or around the outside of the oven door, wipe with a soft cloth. This
may occur when the microwave oven is operated under high humidity condition. And it is
normal.
7. It is occasionally necessary to remove the glass tray for cleaning. Wash the tray in warm sudsy
water or in a dishwasher.
8. The roller ring and oven floor should be cleaned regularly to avoid excessive noise. Simply
wipe the bottom surface of the oven with mild detergent. The roller ring may be washed in mild
sudsy water or dishwasher. When removing the roller ring from cavity floor for cleaning, be
sure to replace in the proper position.
SAVE THESE INSTRUCTIONS