Kettler 2852 - Manual

2852 52” ROUND DINING TABLE
Contents:
(4) Legs
(2) Side Braces
(2) Table feet
(1) Table Top
(16) 1/4 - 20 x 2 1/2” Bolts
(4) 1/4 - 20 x 3” Bolts
Tool Required:
#3 Phillips Head Screwdriver
Assembly Instructions
1.
With the curved side facing out
align the table leg with the predrilled
hole on the foot of the table and insert a
1/4 - 20 x 3” bolt then tighten with the
phillips screwdriver.
Repeat on the other end, do both sets.
1.
Align the predrilled holes on the leg
with the metal insert on the frame,
insert the bolt.
3.
3.
Place the side support
braces vertically between the
legs aligning the predrilled holes.
Insert a 1/4-20 x 2 1/2” bolt thru
the hole into the center brace
then tighten it with the phillips
screwdriver.
Repeat on the other brace, do both sides.
2.
Place the leg with foot
inside the frame underneath the
tabletop. Align the predrilled
holes, insert two 1/4 - 20 x 2 1/2”
bolts then tighten them with the
phillips screwdriver.
Repeat on the other leg, do both sides.
2.
Made in the U.S.A.
www.kettlerusa.com
[email protected]
Copyright
© Kettler USA 309.01