Kenwood TH78E - Manual (Page 33)

Making a DTMF Call
1 Hold the PTT switch down and press the MHz key.
2 Press the numeric key (O-9) for the channel where
the DTMF code is stored.
3 The DTMF code appears on the display.
Note
Transmission continues until the whole code string
is recalled, even if the PTT switch is released.
You cannot stop DTMF code transmission once it
is initiated.
OPERATION AS A REPEATER
(U.S.A., CANADA versions only)
This transceiver is capable of operating as a
repeater. The transceiver listens on both bands
simultaneously. As soon as a signal is received on
one band, the other shifts from receive to transmit
and re-transmits the incoming signal.
Function setting
1 Select the operating frequencies and adjust the
squelch controls to threshold.
2 Press the F key for longer than one second and then
press the 0 key. The MHz dot(.) will flash.
To return to the normal function, perform step 2
again.
Notes
1 The Time-out Timer function will automaticaly set
to 3 minutes mode.
2 Combinations of SHIFT and CTCSS can be
used in the Repeater mode. DTSS and
PAGING will not work in this mode.
CAUTION
This equipment can be extremely susceptible
to lightening strike damage or intermodulation
distortion if it is operated on mountain top
locations.
34