Kenwood TH78E - Manual (Page 62)

2 Memory Expansion Unit (ME-l)
1 Slide the release button to unlock, then pull out
the battery case.
2 Unscrew the four screws on the rear (Fig. 1). The
screw near the antenna connector is a short one.
3 Put your finger into the battery holder, and release
the claw of the rear case. (Fig. 2)
4 Position the set with its front facing forward.
5 Open the front panel from the PTT switch side,
being careful of the internal wiring and water
resistance rubber attached LEDs. (Fig. 3)
6 Attach the ME-l to the transceiver, as shown in
fig.4.
7 Replace the case in its original position, taking
care not to pinch any wires or cables under the
case.
8 Install the four screws.
Fig. 1 Fig. 2
Fig. 3 Fig. 4
64