KORG Krome music workstasion 61key - Manual (Page 104)

Drum Track function
100
Drum Track function settings
Drum Track function settings
in Program mode
Starting/stopping the drum track
1. Access the Prog P7: ARP/DT– Drum Track Pattern
page.
2. “Trigger Mode” specifies how the Drum Track
pattern will be triggered.
Start Immediately: When you press the DRUM
TRACK button to turn it on, the LED will light up and
the Drum Track pattern will start according to the Sync
setting. It will stop when you press the DRUM TRACK
button to turn it off.
Wait KBD Trigger: When you press the DRUM
TRACK button to turn it on, the LED will blink and the
Drum Track pattern will wait to start. When you play
the keyboard or receive a MIDI note‐on, the Drum
Track pattern will start according to the Sync setting.
3. Specify the Sync setting.
Off: The Drum Track pattern will not synchronize to
the arpeggiator that’s currently running, but will start
immediately.
On: The Drum Track pattern will synchronize to the
arpeggiator that’s currently running.
4. If “Trigger Mode” is set to Wait KBD Trigger,
specify the “Latch” setting. “Latch” specifies
whether the Drum Track pattern will continue
playing even after you take your hand off the
keyboard.
Off: If the DRUM TRACK button is on (the LED will
blink), the pattern will start when you play the
keyboard (note‐on). The pattern will stop when you
release the keyboard (note‐off).
On: If the DRUM TRACK button is on (the LED will
blink), the pattern will start when you play the
keyboard (note‐on). The pattern will continue when
you release the keyboard (note‐off). The pattern will
stop when you turn the DRUM TRACK button off (the
LED will go dark).
5. If “Trigger Mode” is set to Wait KBD Trigger,
specify the Keyboard Zone and Velocity Zone.
These settings specify the range of keys and velocities
that will trigger the Drum Track pattern when you play
the keyboard (or receive a note‐on).
Saving the on/off status
If “Trigger Mode” is set to Wait KBD Trigger, the drum
track’s on/off status can be saved in the program.
If “Trigger Mode” is set to Start Immediately, the drum
track’s on/off status will always be saved as “off,”
regardless of the state of the DRUM TRACK button.
EQ adjustments for the Drum Track
program
You can adjust a three‐band EQ for the Drum Track
program.
If you turn “Auto Load Program EQ” on (selected), the
three‐band EQ settings specified for the program will
be automatically loaded when you switch Drum Track
programs. Normally you will leave this selected.
You are free to adjust the three‐band EQ settings that
are loaded automatically. These adjustments are
applied relative to the original settings of the program.