Mechanized processing – Kodak IMAGELITE GAI User Manual

Page 3

Advertising
background image

Mechanized Processing

Notice: Observe precautionary information on products labels and on the Material Safety Data Sheets.

This film can be processed in equipment with mechanical switches or ultrasonic sensors. More details

are available from your Kodak representative or distributor. The following recommendations provide a

range of acceptable developer times and temperatures. Higher development temperatures require

shorter development times. Generally, times and temperatures near the center of the specified range will

produce optimum results for the product. However, criteria other than the development time may dictate

the acceptable processing speed for any particular processor. Within the range given, a development

time should be selected that will provide sufficient fixing, washing and drying of the product. Use

Kodak

RA 2000 developer and replenisher (1:4 dilution) at 85 - 105° F (30 - 40° C) and a development range

of 20 - 45 seconds. Replenishment rates are included in the table below:

Average D-max Area Basic Replenishment Rates

10%

0.12 – 0.15 mL/sq. in. (185 – 235 mL/sq. m)

20%

0.20 mL/sq. in. (310 mL/sq. m)

50%

0.30 mL/sq. in. (465 mL/sq. m)

80%

0.48 mL/sq. in. (745 mL/sq. m)

100%

0.60 mL/sq. in. (930 mL/sq. m)

The starting point recommendation for development is 30 seconds at 95° F (35° C). A 1:2 developer

dilution ratio may be used when intermixing with

Kodak Recording 2000 films. Use Kodak 3000 fixer

and replenisher, part A (1:3 dilution). The basic replenisher rate is 0.35 mL/sq. in. (545 mL/sq. m). Part B

(hardener) may be used at dilutions up to 1:40 (using

diluted

fixer) where film drying problems are being

encountered, or where additional protection from post-process abrasions are required. For batch type

processors where ready-to-use solutions are needed,

Kodak RA 2001 developer and replenisher and

Kodak RA 3001 fixer and replenisher are recommended. If utilization rate will provide at least one tank

turnover per week,

Kodak RA 2050 developer replenisher can be used with lower replenishment rates.

© Kodak, 2006. Kodak and Gen 5 are trademarks of Kodak.

Advertising
This manual is related to the following products: