Kodak SCAN STATION 100 - Manual (Page 101)

6-4 A-61588 July 2008
Replacement
procedures The feed module and USB connector are the only parts that are
customer-replacement.
Replacing the feed module Degradation of feeder performance, multiple feeds, stoppages, etc.
indicate a need to change the feed module. Certain paper types such
as carbonless paper or newsprint, or failure to clean regularly, and/or
use of non-recommended cleaning solvents can shorten the feed
module life.
For additional feed modules, see the section “Supplies and
consumables” at the end of the chapter.
1. Open the Scan Station cover by pressing the release lever.
2. Squeeze the plastic clamps that hold the feed module in place and
lift the feed module out of position.
3. Insert the new feed module into position, aligning the new module
into the slots, and pushing it in until it snaps into place.
4. Close the cover.