Kenwood VR-5090 User Manual
Kenwood Car DVR
Advertising
Table of contents
Document Outline
- VR-5700_5090_5080
- Table of Contents
- Using Your New Kenwood Audio-Video Receiver
- Chapter One: Moving Around
- Chapter Two: Controlling the Receiver
- How Do I Adjust the Sound?
- How Do I Adjust the Surround Modes?
- What is the THX?
- What are Listen Modes?
- Checking the Input signal during playback
- Input Modes (only for input with digital jacks)
- Switching Input Modes
- To set the THX Mode
- To set the Listen Mode manually
- Examples of inputs with which switching is available
- Description of Dolby Pro Logic II: Music mode
- Selecting the parameter of Pro Logic II : Music mode
- Applying Digital Signal Processor (DSP) Effects
- Setting a DSP effect
- HDCDR and D.R.I.V.E. Effects
- Headphone Operation
- Selecting the Inputs
- How Do I Operate Devices?
- Playback of the device connected to the CD2/TAPE2 MONITOR
- Operating a Television
- Operating an AV Device
- Operating a CD player
- To play Kenwood 200-Disc CD Changer
- Single or Rotary CD Player
- CD-R Recorder
- Operating an MD Recorder or Cassette Deck
- Playing an Analog Turntable
- Monitoring a Video Camera or Playing an Additional VCR
- Radio Tuning
- Presetting radio stations
- Recording
- How Do I Adjust the LCD Display?
- Executing Several Operations at Once (Macro function)
- Using Remote Control Unit in Multiple Zones
- Chapter Three: Button Layout in Controlling Other Devices
- Chapter Four: Troubleshooting
- Sound
- I don’t hear any sound at all
- Audio is not output only when a 96k fs compatible disc is played.
- The 96k fs indicator does not light while a 96k fs compatible disc is being played.
- I can’t hear sound from one or more of the speakers, or the sound is abnormally low
- I can’t hear sound from my surround or center speakers
- I can hear sound only from the center speaker when Dolby ProLogic is selected
- A DTS-ES encoded source is played but it is not decoded in DTS-ES.
- A Dolby Digital Surround EX-encoded source is played with THX Surround EX set to “Auto”, but the source is not reproduced in 6.1-channel audio.
- Sound from one (or more) of my components is abnormally loud or soft
- I can’t hear sound from some of my laser discs
- There wasn’t any sound recorded on tapes made on my VCR or tape deck
- The initial sound is intermittent or non-existent when I start to play from a Dolby Digital, DTS, DTS-ES or MPEG source
- With a Dolby Digital program or DTS program, the loud sounds aren’t very loud and the quiet sounds aren’t very quiet
- All I hear is loud static when I play DTS discs
- I hear a hum when I select the PHONO input
- I can’t hear any sound in Zone B
- Video
- Remote Control unit
- Receiver/Tuner
- My receiver won’t turn on and the STANDBY indicator is flashing
- The sound is distorted, and the CLIP indicator on the receiver’s front panel flashes red continually, or stays red for more than 1second at a time.
- I can’t receive a radio station
- I’m getting a lot of static/interference
- When I press a button to tune to a preset station, the receiver does not respond.
- Sound
- Numerics