Kenmore THE ECONOMIZER 153.33206 - Manual (Page 23)

23
OPERATING INSTRUCTIONS
FLAMMABLE
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
A.
B.
C.
D.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the
fire department.
Do not touch any electric switch;
do not use any phone in your building.
1.
1.
2.
3.
STOP! Read the safety information above
on this label.
Set the ON/OFF switch on the control box to the
"ON" position.
4. Set the ON/OFF switch on the control box to the
"OFF" position.
Set the ON/OFF switch on the control box to the
"ON" postition.
Turn on all electrical power to the appliance.
WATER TEMPERATURE ADJUSTMENT is
approximately 120
o
F.
CAUTION: Hotter water increases the risk of
scald injury. Consult the instruction
manual before changing temperature.
WARNING: TURN OFF ALL ELECTRIC
POWER BEFORE SERVICING.
WARNING: If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal injury
or loss of life.
FOR YOUR SAFETY READ BEFORE LIGHTING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
5.
6.
7.
Turn off all electrical power to the appliance if
service is to be performed. 3.
8.
Set the ON/OFF switch on the control box to the
"OFF" postition. 2.
10.
11.
This appliance is equipped with a device
which automatically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
If the appliance will not operate, follow the instruc-
tions "TO TURN OFF GAS TO APPLIANCE" and
call your technician or gas supplier.
HOTTER COOLER
C B A
HOT
VERY
VACATION
WARM
--------------
----------------------- ---------------------- ------------------------------
------------------------------------------------------
* -----------------------------------------------------------------------
* ----------------------------------------------------------
--------------------------------------------------------------------------------------
--------------------------------------------------------------------------------------
* ------------------------------------------------------------------------
-----------------------------------------------------------------------------------------------
------------------------------------------------------------------------------------------------------------------------
--------------------------------------------------------
This appliance does not have a pilot. It is equipped with
an ignitiion device which automatically lights the
burner. Do not try to light the burner by hand.
BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
Use only your hand to push in the gas control but-
tons. Never use tools. If the control buttons will not
push in, don't try to repair them, call a qualified ser-
vice technician. Force or attempted repair may
result in a fire or explosion.
Do not use this appliance if any part has been
under water. Immediately contact a qualified
installer or service agency to replace a flooded
water heater. Do not attempt to repair the unit.
It must be replaced!
Set the thermostat to the lowest setting by first
pressing the COOLER and HOTTER but-
tons together and holding for 1 second. Then press
the COOLER button until the Warm indicator
light appears.
Set the thermostat to the lowest setting by first
pressing the COOLER and HOTTER but-
tons together and holding for 1 second. Then press
the COOLER button until the Warm indicator
light appears.
9. Set the thermostat to the desired setting by first
pressing the COOLER and HOTTER but-
tons together and holding for 1 second. Then press
the HOTTER button
Wait five (5) minutes to clear out any gas.
If you then smell gas, STOP! Follow "B" in
the safety information above on this label. If you
don't smell gas, go to the next step.