Kenwood KDC-MP642U - Manual (Page 51)

English | 51
Connecting Wires to Terminals
P.CONT
ILLUMI
ANT.
CONT
MUTE
– +
REMO.CONT
L R
L R
FM/AM antenna input
Front output
Fuse (10A)
Microphone
(Accessory5)
Microphone input
(KDC-X993 only)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left speaker
To front right speaker
To rear right speaker
To rear left speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
Ignition key
switch
Car fuse box
(Main fuse)
ACC
Car fuse
box
Battery
If no connections are made, do not let the wire come out from the tab.
Power control wire (Blue/White)
Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
When using the optional power amplifier, connect to its power control
terminal.
To car light control switch
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type or short pole type antenna.
Sub Woofer output
TEL mute wire (Brown)
Rear output
To use the steering wheel
remote control feature, you
need to an exclusive remote
adapter (not supplied)
matches your car is required.
Steering remote control
(Light Blue/Yellow)
To Kenwood disc changer/ External optional accessory
⁄ To connect these leads, refer to the relevant
instruction manuals.
Connect to the terminal that is grounded when either the telephone
rings or during conversation.
⁄ To connect the Kenwood navigation system, consult your
navigation manual.
USB connector (1m)
To USB device
⁄ Do not remove the cap when you do
not use the USB cable. The connector
will cause the unit to malfunction if it
gets in touch with any metallic part of
the vehicle.
Wiring harness
(Accessory1)
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.