Konica Minolta BIZHUB 210 - Manual (Page 180)

7 Using the utility mode
7-12 bizhub 162/210
7.2 Paper source settings
From the PAPER SOURCE SETUP menu, the various settings for each paper
tray can be specified.
No. Name Description
1 INCH/METRIC This function can be used to set the size measurement system for
the paper loaded in each tray. It can be used to select whether pa-
per measured in centimeters (METRIC), such as A4 and B5 sizes,
or paper measured in inches (INCH), such as Letter size, is load-
ed. If no particular setting is selected, the paper size is detected
automatically.
• Default setting: METRIC.
2 TRAY1 PAPER This function can be used to set the type of paper (PLAIN, OHP,
CARD or ENVELOPE) loaded into the 1st tray, and the size of the
paper (AUTO or SIZE INPUT). If the paper size is set to SIZE IN-
PUT, type in the paper size.
• Default setting: PLAIN and AUTO.
3 PAPER TYPE This function can be used to specify the type of paper loaded into
a tray, which determines whether or not the paper is available with
the Auto Paper function or the tray is available with the auto tray
switching feature. Select the paper type (PLAIN, RECYCLE or
SPECIAL) to specify whether the paper is available with the Auto
Paper function or the tray is available with the auto tray switching
feature.
If special paper is loaded into the tray, PLAIN, RECYCLE, SPE-
CIAL or 1-SIDE must be selected.
PLAIN
The Auto Paper function can be selected, the auto tray switching
feature is available, and double-sided copies can be made.
RECYCLE
The Auto Paper function cannot be selected; however, the auto
tray switching feature is available, and double-sided copies can
be made.
SPECIAL
The Auto Paper function cannot be selected, and the auto tray
switching feature is not available; however, double-sided copies
can be made.
1-SIDE
The Auto Paper function can be selected and the auto tray switch-
ing feature is available only when making single-sided copies. In
addition, double-sided copies can be made.
• Default setting: PLAIN.