Klark Teknik DN9344E User Manual

Page 30

Advertising
background image

HELIX DN9340E/DN9344E Remote Control Software

User Guide


30 of 65

6

Select the IP address of the HELIX

DN9340E/DN9344E unit you wish to connect to

this port, for example, “192.168.1.22”.


7

Make sure Echo is set to Generic Echo Off.

8

Click OK to accept port change, or Cancel to decline.

9

Assign port to device by

selecting device in List of Devices
and selecting port in the

available ports appropriate to

device in drop down list
(right-hand side), for example,

“Unit 1”.


The name of the assigned port

will appear under the Assigned
Port
column (highlighted in
yellow opposite).

10

Click OK.

Your system should now be ready for online operation, as described in Section 7.6. Successful
HELIX RCS/unit communication is indicated on the units by the yellow NETWORK LED illuminating.

Advertising
This manual is related to the following products: