7 solo tracking operation – Klark Teknik DN9344E User Manual

Page 46

Advertising
background image

HELIX DN9340E/DN9344E Remote Control Software

User Guide


46 of 65

7.7 Solo

Tracking

Operation

If required, the Solo Tracking system of the Midas mixing console in use can be set up to select the

slave equalisers in the Helix Network. To enable this, the various Solo Tracking buttons must be
assigned to Helix channels via the System Solo Tracking Setup screen (shown below) and the settings

downloaded to a DN9340 Helix unit that is currently connected to the console Solo Tracking output (the

DN9344 does not have a Solo Tracking input).

To open the System Solo Tracking Setup screen

Switch to the FastNav

®

screen and choose Solo Tracking.

The screen contains a scrollable list similar to the Solo Tracking System Configuration page of the

DN9340E Helix unit, showing the 32 HELIX equaliser channels and their currently assigned solos.

Assignments are made via the fields in the Solo Tracking Setup panel at the right-hand side. The

available Solo Source and Num settings change to match the chosen Console Type.

To assign solo sources to HELIX channels

1

Specify the console to be used for the performance in the Console
Type
field in the top right-hand corner of the screen. Any
current assignments that are not valid for the chosen console

are flagged as invalid by an asterisk in the right-hand column.

2

Highlight the HELIX channel in the list and choose the required
Solo Source from the drop down list on the right-hand panel and

then choose a number from the Num drop down list. (The Num

list changes to suit the selected Solo Source).

This field defaults to the

Master Unit set in the

Function Lockout screen

List of console

Solos buttons

assigned to the

EQ channels

Name changes
will be copied
to Device

screens

Solo selections
change to match

Console Type

Clear all the
current

assignments

Advertising
This manual is related to the following products: