Kenwood M1GD50 - Manual (Page 8)

English 
For first use
Connecting stereo headphones
1
Switch the Player ON.
Press and hold the Power/Menu button until the
KENWOOD logo is displayed.
The Player enters the mode before the last time it was
switched OFF.
2
Switch the Player OFF.
Press and hold the Power/Menu button until the pattern
shown on the left is displayed.
• The display is turned off automatically when the Player has not been operated for a certain
period of time (screen saver mode). The Power/Menu button blinks every 3 seconds in the
screen saver mode. The time until the screen saver mode is activated can be changed (page
23).
HOLD function
The HOLD function defeats all of the Player’s buttons and helps prevent erroneous
operation when the Player is carried in a bag, etc.
The HOLD function should be canceled before using the Player.
HOLD
RESET
HOLD
RESET
HOLD
HOLD
HOLD canceled
HOLD
• When the HOLD function is switched on and the display is in the screen saver mode, the
Power/Menu button blinks twice every 3 seconds. " " is displayed when the display is turned
on.
Switching Power ON/OFF
Connect the provided stereo headphones to the Player.
Entanglement-prevention slider
. (
Hold the headphone body and insert into each
ear. The optimum condition is when the ear hole
is stopped completely by the ear tip.
Selecting the ear tips
The headphones are shipped from the factory with the M-size ear tips attached. If the M-
size ear tips do not match your ears, replace them with the provided S-size or L-size ear tips.
S-size
M-size
L-size
• Always hold the headphone bodies when attaching or detaching headphones. Pulling a cord
may result in malfunction.
• To clean the ear tips, remove them from the headphone bodies and wash with a neutral
detergent solution. After washing, wipe them dry before use.
• The ear tips may deteriorate after a long period of use or storage.
• To prevent the headphone cord from being entangled, slide the entanglement-prevention
slider to fix the headphone bodies in position.