Konica Minolta DI3510 - Manual (Page 240)

11
Specifying Copy Settings
11-8 Di2510/Di3010/Di3510
To make copies using the “Hole Punch” setting
1
Position the document(s) to be
copied.
❍ For details, refer to “10 Original
Documents”.
2
Select “Non-Sort”, “Sort” or “Group”,
and then touch [Hole Punch].
3
Touch [Select Position].
4
Touch the button for the desired
hole punch positions.
❍ To allow the hole punch position
to automatically be specified,
touch [OFF].
5
Touch [Enter].
6
Press the [Start] key.
The copies are printed.
✎
Tip
If copying is started without the hole punch position specified or if
"OFF" was selected, the hole punch position is automatically
specified according to the document orientation, as shown below.
To adjust the position of the punched holes, contact your service
representative.