Konica Minolta DI3510 - Manual (Page 77)

Before Making Copies
4
Di2510/Di3010/Di3510 4-13
To turn off the copier
1
Touch [Activity List] to check that no
jobs are queued.
2
If any printed pages remain in the
paper output tray, remove them.
3
Press the sub power switch to turn
off the copier.
4
Set the power switch to “O”.
✎
Tip
Normally, it is not necessary to set the power switch to “O”.
✎
Note
When turning the copier off, then on again, wait five seconds after
turning it off before turning it on again. If no time passes between
turning the copier off until turning on again, the copier may not
operate correctly.
Do not turn off the copier while it is making copies or printing,
otherwise a paper misfeed may occur.
Do not turn off the copier while it is scanning or sending or
receiving data, otherwise all scanned data or transmission data will
be deleted.
Do not turn off the copier while a queued job or stored data is
waiting to be printed, otherwise the jobs will be deleted.
When the copier is turned off
● Settings that have not been programmed will be cleared.
● Jobs that are queued to be printed are deleted.
● Data scanned using the “Scan to Memory” function is deleted.
● Scanned data that could be printed using the “Memory Recall” function
is deleted.