Lennox Hearth COUNTRY COLLECTION 506033-35 - Manual


NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
FREESTANDING BLOWER SNAp SWITCh RETROFIT KIT
COUNTRY COLLECTION™ WOODSTOVES
p/N 506033-35
Rev. NC, /2009
HEARTH PRODUCTS
KITS AND ACCESSORIES
KIT CONTENTS
1 ea. Blower Wire Harness (item #1)
1 ea. Snap Switch and Control Panel Housings (item #2)
1 ea. 6” of 3/4” Heat Shrink Tube (item #3)
2 ea. Butt Connectors (item #4)
3 ea. Wire Ties (item #5)
1 ea. Instruction Sheet
TOOLS NEEDED
5/32 Allen Wrench Or T Handle Wrench
Cutting Pliers
Wire Crimpers
9/16” Socket Wrench
9/16” Open End Wrench
Crescent Wrench
3/8” End Wrench
Large Flat Head Screwdriver
FPO
INSTALLATION INSTRUCTIONS FOR INSTALLING A BLOWER SNAp SWITCh
RETROFIT KIT FOR USE WITh COUNTRY COLLECTION™ MODELS S60, SA60,
SS20, ST20, S260 AND ST30 FREESTANDING WOODSTOVES
WARNINGS
The blower must be plugged directly into a properly
grounded three-prong receptacle, 20 VAC, 60 hz, single
phase. Do not cut or remove the grounding prong from
this plug. Do not route power cord under or in front of
appliance.
Installation must be in accordance with National Elec-
trical Code, ANSI/NFpA 70 - latest edition. In Canada,
the current CSA C22- Canadian Electrical Code - latest
edition.
DANGER: Disconnect power before servicing blower.
In the event that you remove the blower for any reason,
make sure a cover plate (available from Lennox hearth
products) is installed before using the heater. Excessive
rear wall temperatures will result if the stove is burned
without the cover plate. The cover plate is not necessary
if a blower has never been installed because a knock-out
will be in place to act as the cover.
FREESTANDING BLOWER SNAp SWITCh RETROFIT KIT
Cat. No. Model Description
h798 SSK-BLWR-FSB700 Blower Retrofit Kit, FS Woodstoves
Figure 1 - Kit Contents
GENERAL INFORMATION
This retrofit kit works in conjunction with the optional 700-CFM room air
circulation blower kit. The kit provides a variable speed control (rheostat)
and snap switch, which will allow for the option of automatic thermal
activation of the blower, when desired and blower speed control (see
Blower Operation on Page 8).
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact your local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installa-
tion.
ALL WARNINGS AND pRECAUTIONS IN ThE INSTALLATION AND
OpERATION MANUAL pROVIDED WITh ThE AppLIANCE AppLY TO
ThESE INSTRUCTIONS.
ShUT DOWN ThE STOVE AND ALLOW IT TO COMpLETELY COOL BEFORE
pROCEEDING.

4
2
3
5