Lux Products TX9600TS - Manual (Page 24)

words “COPY PROGRAM” will flash briefly at the top of the screen, followed
by “FROM” and “TO”. Under the word “FROM” will be a flashing day of the
week. Using the UP and DOWN buttons, select the day that you want to copy
from. Press the NEXT button one time. Your copy from day should now be
on steady with the day under the word “TO” flashing. Use the UP and DOWN
buttons to select the day that you would like to copy to. A single short press
of the COPY button will perform the copy, and the day flashing under the
word “TO” will have advanced to the next following day. You may continue
to perform short single presses of the COPY button to keep copying from the
original source day to the remaining days, one after the other. Specific days
may be skipped by pressing the UP button, to advance past them while they
are flashing under the word “TO”. Press the EXIT button to return to the
Normal Run screen.
TEMPERATURE SWING SETTING, OFFSET SETTING, AND TEMPERATURE
CALIBRATION:
NOTE: The Swing setting, Offset setting, and Calibration settings need to be
performed in a timely manner, as the thermostat will timeout and
automatically exit these adjustment screens after approximately 10 seconds
without a button press.
SWING DESCRIPTION: A thermostat works by turning your heating or
cooling system on and off whenever the room temperature varies from the
desired set-point temperature. The amount of this variation is called the
Swing. Generally your system should cycle on about 3 to 6 times per hour.
A smaller swing number makes the system cycle more frequently, so the
room temperature is more precise and constant. A larger swing number will
make the system remain on for a longer duration each time and decreases
the number of cycles per hour. There is only one Swing setting, and this
determines the cut-in and cut-out points for both the first and second stages
(if present), in both Heat mode and Cool mode. The swing setting range is
between #1 and #9 (0.25°F to 2.25°F, in 0.25°F degree increments (or 0.14°C
to 1.25°C, in 0.14°C degree increments for Celsius)). Swing number 1 is the
default setting.
OFFSET DESCRIPTION: This setting is shown as a number of degrees, and is
similar in nature to the Swing however this only effects the operation of the
second (auxiliary) heating stage, if present. The setting range for Offset is
24
ADVANCED FEATURES: