LG C Series - Manual (Page 27)

Chapter 5. Programming keypad
5.3 Moving to other groups
z There are 4 different parameter groups as shown below.
Drive group
Function
group 1
Function
group 2
I/O group
Drive group Basic parameters necessary for the inverter to run. Parameters such
as Target frequency and Accel/Decel time are settable.
Function group 1 Basic function parameters to adjust output frequency and voltage.
Function group 2 Advanced function parameters to set parameters for such as PID
Operation and second motor operation.
I/O (Input/Output)
group Parameters necessary to make up a sequence using Multi-function
input/output terminal.
z Moving to other parameter groups is only available in the first code of each group as
the figure shown below.
Moving to other groups using the Right ( X) key Moving to other groups using the Left ( W) key
Function
group 1
Function
group 2
I/O group
Drive group
*
Function
group 1
Function
group 2
I/O group
Drive group
*
*
Target frequency can be set at 0.0 (the 1
st
code of drive group). Even though the preset value is 0.0, it is user-settable.
The changed frequency will be displayed after it is changed.
27