Land Pride Powered Rakes PR1672 - Manual (Page 27)

25
Section 7: Troubleshooting
6/12/13 PR1660, PR1672 & PR1690 Powered Rakes 314-216M
Table of Contents
Section 7: Troubleshooting
Problem Solution
Machine makes intermittent clicking
noise Check for damaged gear and replace if necessary.
Check for worn drive chain and replace if necessary.
Roller will not turn Obstruction between roller and material control deflector.
Chain is off.
Burnt or mis-adjusted slip-clutch on driveline shaft.
Broken drive spindle.
Operating depth insufficient Raise gauge wheels.
Increase tractor RPM.
Clean roller.
Roller gouging on the end The gauge wheel on chain case side should be approximately 1" lower than the
non-drive side gauge wheel for consistent leveling.
Set gauge wheel depth.
Correct air pressure in gauge wheels.
Level 3-Point arms on tractor.
Too much dirt going into the windrow or
dirt going over the top of the material
control deflector Reduce ground speed.
Raise material control deflector.
Lower gauge wheels.
Too many rocks passing between
material control deflector and the roller Lower material control deflector.
Roller balling up with soil Wait until soil dries.
Powered Rake bumping on ground Clean roller.
Increase roller speed if roller is turning slow.
Decrease roller speed if roller is turning fast.