Lenoxx Electronics HT-391 - Manual (Page 16)

15
Home Theater System + TV + VCR + Satellite
TV + VCR + SATELLITE RECEIVER CONNECTIONS
1. Follow the same on P14 to connect your VCR with your HOME THEATER SYSTEM.
2. To hear the sound of the satellite programs through your HOME THEATER SYSTEM, just insert a set of audio cables
(optional, not included) into one pair of the 3 audio input jacks of your HOME THEATER SYSTEM, and into the
corresponding AUDIO OUT jacks of your SATELLITE RECEIVER/CABLE BOX.
3. Your RF (coaxial) cable connection from your SATELLITE RECEIVER/CABLE BOX to your VCR is unchanged, the
same as before.
NOTE: You will hear sound from both the TV and your HOME THEATER SYSTEM, this is normal.
4. Insert the AC power cord into an AC outlet.
5. Make sure the POWER switch on the back of the main unit is at “ON” position. Next press the ON/STANDBY button on
the front of the main set or on the REMOTE to turn the set on (or off).
NOTE: The factory’s default input source is DVD with 5.1 channel sound output. When the set is turned to
ON, the DVD indicator and 5.1 channel indicator will be on and sound will come out of 5 speakers plus
the subwoofer. To change 5.1 channel to 2 channel output, press the SPEAKER CHANNELS button. The sound
will come out of only 2 front speakers plus the subwoofer.
6. Press the INPUT SOURCE button several times till the AUX indicator lights.
7. Make sure your VCR is on and follow your VCR’s instructions.
8. Go to Page 21 for other detailed instructions.
CONNECT ALL SPEAKERS AS SHOWN ON PAGE 8 (OR THE QUICK SETUP DIAGRAM SHEET).
SATELLITE RECEIVER/CABLE BOX CABLE OR
ON AIR ANTENNA/
SATELLITE SIGNAL
RF (coaxial) cable
unchanged, same as
before.