Little Wonder 6232 - Manual (Page 3)

15. STORE MACHINE INDOORS - When not in
use, store indoors in a dry place, locked or otherwise
inaccessible to children.
16. DO NOT ATTEMPT TO REPAIR MACHINE
- Have repairs made by qualified dealer or repairman.
Use only original Little Wonder replacement parts.
17. HANDLE GAS WITH CARE; IT IS HIGHLY
FLAMMABLE.
a) Use a gas container acceptable for the purpose
and do not store gas in the house.
b) Never add gas to a running or hot engine.
c) Fill gas tank outdoors with extreme care. Never
fill gas tank indoors.
d) Replace gas cap securely.
e) If gas is spilled, move Edger and gas container
from area and do not create a source of ignition.
18. To reduce the risk of
fire, replace gasoline cap
securely.
19. START THE ENGINE CAREFULLY. Keep
hands, feet, clothing and the like well away from
blade and moving parts.
20. NEVER ATTEMPT TO MAKE ADJUST-
MENTS while the engine is running, except to the
carburetor.
21. DO NOT RUN THE
ENGINE INDOORS -
Exhaust flames are dangerous The engine exhaust
from this product contains chemicals known to the
State of California to cause cancer, birth defects or
other reproductive harm.
22. IF BLADE STRIKES A FOREIGN OBJECT,
FOLLOW THESE STEPS:
a) Stop the engine.
b) Disconnect the spark plug lead.
c) Inspect for any damage.
d) Repair any damage before restarting and
operating the machine.
23. DISENGAGE THE BLADE AND/OR STOP
THE ENGINE WHEN THE MACHINE IS
TRANSPORTED OR NOT IN USE.
CAUTION
▲
!
▲
!
WARNING
▲
!
▲
!
24. STOP THE ENGINE WHEN LEAVING THE
MACHINE UNATTENDED.
25. WHEN CLEANING, REPAIRING, OR
INSPECTING, make certain the blade and all mov-
ing parts have stopped. Disconnect the spark plug
wire, and keep the wire away from the plug so that
unintentional starting does not occur.
26. NEVER OPERATE THE MACHINE without
guards or other productive devices in place. Before
each use, check all fasteners and safety devices for
proper function.
27. MULTIPLE OPERATORS - Keep a safe
distance between two or more operators when
working together simultaneously.
28. BE SURE MACHINE IS FULLY
ASSEMBLED - Never operate without all guards
and deflectors in place. Ensure that all nuts, bolts,
screws are installed and properly tightened. Check
pulley set screws and all fasteners for tightness and
lubricate cutter head shaft, key, keyway and bushings
with light oil prior to each use.
29. ALWAYS KEEP THE THROTTLE IN THE
“STOP” POSITION WHEN NOT IN USE.
30. LABELS SHOULD BE INSPECTED
BEFORE EACH USE. Replace damaged labels
immediately. See Safety Decal Identification on
page 4.
3