Lincoln Electric K520 UTILITY IM468-A - Manual (Page 10)

A-4 A-4
WELDER MOUNTING INSTRUCTIONS
Small SP welder and Weldpak to the Utility Cart
Parts Required:
Part Number Description Required
S19528 Mounting Clip 3
CF000014 1/4-20 x .75 screw 3
T9860-6 Lock Washer 3
CF000017 1/4-20 Hex Nut 3
Refer to FIGURE 8 while mounting your welder.
STEP 1
Secure one Welder Clip in position with a bolt, lock-
washer, and nut Note that the overhanging edge of
the Welder Clip must face toward the door of the
welder, so that the welder covers the bolt head when
installed.
STEP 2
Position your welder as shown. Open the welder
door, and slide the welder over the bolt head, engag-
ing the lower lip of the welder with the overhanging
edge of the Welder Clip.
STEP 3
On the opposite side of the welder, remove the front
and rear self-tapping screws which secure the case
side. Attach two Welder Clips to the case side, using
the same holes and screws. The overhanging edge of
the Welder Clip must face away from the welder.
STEP 4
Adjust the welder position so that the holes in the
Welder Clips line up with holes in the Utility Cart as
shown. Secure the clips to the Cart with two bolts,
two lockwashers, and two nuts.
THE HANDLE ON YOUR WELDER IS NOT TO BE
USED FOR LIFTING WHEN THE WELDER IS
ATTACHED TO THE UTILITY CART. THE HANDLE
IS FOR LIFTING THE WELDER ONLY! DO NOT LIFT
BY THE HANDLE WHEN THE CART IS ATTACHED!
------------------------------------------------------------------------
See GAS CYLINDER MOUNTING INSTRUCTIONS if
a cylinder is to be used.
FIGURE 8
CAUTION