Lincoln Electric K520 UTILITY IM468-A - Manual (Page 11)

A-5 A-5
AC-225-C WELDER TO THE UTILITY
CART
Parts Required:
Part Number Description Required
S8025-54 1/4-20 x 1.25 4
Screw
Refer to FIGURE 9 while mounting your AC-225-C
welder.
Position the AC-225-C as shown. Attach the AC-225-
C with four 1/4 x 1 1/4 in. Self-tapping screws from
underneath using the holes provided in the base of
the AC-225-C and the Utility Cart.
If desired, the chain and buckle/strap assemblies may
be removed, since a gas bottle is not required when
welding with an AC-225-C.
THE HANDLE ON YOUR AC-225-C IS NOT TO BE
USED FOR LIFTING WHEN THE AC-225C IS
ATTACHED TO THE UTILITY CART. THE HANDLE
IS FOR LIFTING THE AC-225-C ONLY! DO NOT
LIFT BY THE HANDLE WHEN THE CART IS
ATTACHED.
------------------------------------------------------------------------
FIGURE 9
GAS CYLINDER MOUNTING
INSTRUCTIONS
GAS CYLINDERS LESS THAN 15 INCHES
(40CM) TALL
Set the cylinder upright on the rear of the Bottom
Shelf. Secure in place with the Strap and Buckle
Assembly. The cylinder must be held tightly against
theTank Support. The chain is not used.
GAS CYLINDERS GREATER THAN 15
INCHES (40CM) TALL
Set the cylinder upright on the rear of the Bottom
Shelf. Secure in place by looping the Chain around
the bottle, and passing the end of the chain through
the keyhole slot in the Top Shelf. Lock the link that
gives the tightest fit around the bottle in the narrow
slot. Secure the lower portion of the bottle with the
strap and Buckel Assembly. Both the Chain and the
Strap Assembly must be used.
CAUTION
CYLINDER could explode
if damaged.
• Keep cylinder upright and chained
to a support.
• Keep cylinder away from areas where it could
be damaged.
• Never lift welder with cylinder attached.
• Never allow the welding electrode to touch the
cylinder.
• Keep cylinder away from welding and other live
electrical circuits.
___________________________________________
WARNING