Troubleshooting – LG HCS6300 User Manual

Page 48

Advertising
background image

48

206-4122

Troubleshooting

This section provides troubleshooting information for the HCS6300. You can find additional

troubleshooting help at www.DIRECTV.com.

Equipment Setup Review

• Make sure all connectors and connections are tight and secure on all entertainment system

components.

• Check the Ethernet connection; is it viable and working?
- Observe the green and amber LEDs on the Ethernet connector.
- The green LED should blink rapidly.
- The amber LED should stay lit constantly.
• Ensure the COM 23 access card is installed, up-to-date, and authorized by DIRECTV.

STATUS LED

The green STATUS LED on the HCS6300 front panel provides general information about the

operating condition of the card. Observe the STATUS LED, and refer to the following table:

STATUS LED Behavior

Operating Status

Slow Blinking

Power Up State

Rapid Blinking

Error Condition

Continuously On

Normal Operation

Continuously Off

Fault Condition, No Output

Audio/Video Freeze or Blank Screen

Perform one or more of the following (in order):
• Remove and reinsert the COM 23 access card.
• Press the RESET button located on the front of the COM 23, and allow the STB to retrieve

the DIRECTV program guide.

• Unplug the power cord of the COM 23 for 15 seconds; then plug it in again.
• Use a small object (for example, a paperclip) to press the recessed RESET button on the

HCS6300. Hold for five seconds to initiate the reset.

• Unplug the power cord of the CodePlus card frame for 15 seconds; then plug it in again.

Advertising