Turning on the phone – Linksys SPA 922 User Manual
Page 9
5
2: Installing
Turning on the Phone
SPA IP Phone
IP Phone SPA942
Turning on the Phone
This section assumes that the correct connections have been made.
Plug in the AC power adapter to an electrical outlet. Use only the adapter that came with the phone.
•
The phone will execute a boot-up sequence when the power source is connected.
•
During this sequence, the display will first show LINKSYS® and then “Initializing Network”.
•
All of the lights on the phone will flash.
•
After the sequence, which should take about five seconds, the phone will display the standard menu for
the phone.
•
The date, name and number of the phone will display on the top line of the LCD screen.
At the bottom of the LCD screen redial, dir, cfwd and dnd are displayed over their associated soft buttons. A
small arrow appears next to dnd indicating that more menus can be accessed by pushing the right side of the
navigation button.
If the phone does not provide this screen, re-confirm installation and connections. If these are correct, try
unplugging the phone and plugging it back in again. If you still don’t see the display, then contact your Phone
Administrator or service provider.
Figure 2-4: SPA941/942 LCD screen display