Deck mechanism disassembly, Plate top (fig. a-2-1), Holder assembly cst (fig.a-2-2) – LG TL-AT130M User Manual

Page 41: Opener door (figure. a-2-3), Bracket assembly l/d motor (fig. a-2-4), Gear assembly rack f/l (fig. a-2-5), Arm assembly f/l (fig. a-2-6), Lever assembly s/w(fig. a-2-7)

Advertising
background image

4-4

DECK MECHANISM DISASSEMBLY

2. Plate Top (Fig. A-2-1)

1) Pull the (B) portion of the Plate Top back in direction of

arrow and separate the right side of it.

2) pull the (B’) portion of the Plate Top back in direction of

arrow and separate the left side of it.
(Used tools : (-) type driver, anything tool with sharp
point or flat point.)

NOTE

(1) When reassembling, push the Plate Top after alignment

the two position(C), (C’) as below Fig.

3. Holder Assembly CST (Fig.A-2-2)

1) Move the Holder Assembly CST in direction of arrow and

separate the left side of it first through the (D) position of
the Chassis.

2) Disassemble the right side of the Holder Assembly CST

from each guided hole of the Chassis.

NOTE

When reassembling, insert the (E) part of the Holder
Assembly CST in the (E’) hole of the Chassis first and
assemble the left side of it.

4. Opener Door (Figure. A-2-3)

1) Turn the Opener Door clockwise and remove it through

the guide hole of the Chassis.

5. Bracket Assembly L/D Motor

(Fig. A-2-4)

1) Unplug the Connector(C1).

2) Unhook three Hooks(H3, H4, H5) on bottom side of the

Chassis, lift up the Bracket Assembly L/M and disassem-
ble the Bracket Assembly L/D Motor.

6. Gear Assembly Rack F/L (Fig. A-2-5)

1) Move the Gear Assembly Rack F/L in direction of

arrow(A) and unhook the Hook(H6) pulling back in front.

2) Separate the Gear Rack F/L in direction of arrow(B).

NOTE

When reassembling, align the gear part of the Gear
Assembly Rack F/L with the Gear Drive as below Fig.

7. Arm Assembly F/L (Fig. A-2-6)

1) Move the Arm Assembly F/L in direction of arrow and

separate the left side of it first.

2) Disassemble the Arm Assembly F/L from each guided

hole of the Chassis.

8. Lever Assembly S/W(Fig. A-2-7)

1) Unhook the Hook(H8) in the left side of the Chassis and

remove the Lever Assembly S/W.

(B')

(C')

(C)

(B)

(D)

Holder assembly CST

Chassis

Gear Rack F/L

Gear Drive

(H8)

Chassis

(H3)

(H4)

(H5)

Bracket assembly L/M

Advertising