Linear DXS-10 - Manual

INSTR,INST,DXS-10
LINEAR P/N: 213007 D
MATERIAL: 20 LB. MEAD BOND
SIZE: 8.500" x 11.000"
INK: BLACK
SCALE: 1-1
DXS-10
WIRELESS
KEYPAD
For Use With DVS-2400
Security Console
Installation
Instructions
1. KEYPAD DETAIL 2. TYPICAL WIRELESS KEYPAD PLACEMENT
KEYPAD FOR
ENTERING YOUR
USER CODE
PRESS THE STAR
KEY TO RESET THE
KEYPAD IF YOU ENTER
THE WRONG CODE
MODE BUTTONS
FOR CHANGING
MODES
GREEN
OPERATION
LIGHT
EMERGENCY
BUTTON TO
SOUND SIREN
AT ANY TIME
FIRE BUTTON
TO SOUND
SIREN AT ANY
TIME
KEY TO ACTIVATE
HOME AUTOMATION
OUTPUT (A)
PRESS AND
HOLD FOR
2 SECONDS
TRANSMITTERS
BEDROOM
MAIN
CONSOLE
WIRELESS
KEYPAD
WINDOW
KITCHEN
FRONT
ROOM
FRONT
DOOR
3. OPENING KEYPAD 4. TABLE-TOP USE 5. WALL MOUNTING (INDOORS ONLY)
6. CLOSING KEYPAD 7. PROGRAM KEYPAD INTO CONSOLE LINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and workmanship
for twelve (12) months. The Warranty Expiration Date is labeled on the product.
This warranty extends only to wholesale customers who buy direct from Linear
or through Linear’s normal distribution channels. Linear does not warrant this
product to consumers. Consumers should inquire from their selling dealer as to
the nature of the dealer’s warranty, if any. There are no obligations or liabilities
on the part of Linear Corporation for consequential damages arising out of or
in connection with use or performance of this product or other indirect
damages with respect to loss of property, revenue, or profit, or cost of removal,
installation, or reinstallation. All implied warranties, including implied warranties
for merchantability and implied warranties for fitness, are valid only until Warranty
Expiration Date as labeled on the product. This Linear Corporation Warranty is
in lieu of all other warranties express or implied.
All products returned for warranty service require a Return Product Authorization
Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA#
and other important details.
IMPORTANT !!!
Linear radio controls provide a reliable communications link and fill an important
need in portable wireless signalling. However, there are some limitations which must
be observed.
✶ For U.S. installations only: The radios are required to comply with FCC Rules
and Regulations as Part 15 devices. As such, they have limited transmitter
power and therefore limited range.
✶ A receiver cannot respond to more than one transmitted signal at a time and
may be blocked by radio signals that occur on or near their operating
frequencies, regardless of code settings.
✶ Changes or modifications to the device may void FCC compliance.
✶ Infrequently used radio links should be tested regularly to protect against
undetected interference or fault.
✶ A general knowledge of radio and its vagaries should be gained prior to acting
as a wholesale distributor or dealer, and these facts should be communicated
to the ultimate users.
Copyright © 2001 Linear Corporation 213007 D
USE THE FOUR SCRATCH
DETERRENT PADS PROVIDED
FOR TABLE-TOP USE
CONNECT BATTERY
TO BATTERY CLIP
FROM TOP OF CASE TWIST
SCREWDRIVER BETWEEN
CASE HALVES UNTIL IT
POPS OPEN
ATTACH REAR CASE TO WALL
WITH THE TWO SCREWS PROVIDED
MOUNT AT A CONVENIENT
LOCATION NEAR PRIMARY
ENTRY/EXIT DOOR
FIRST HOOK BOTTOM
EDGE TOGETHER
THEN, SNAP CASE SHUT
2
1
HOLD OFF BUTTON
FOR 3 SECONDS WHEN
FINISHED TO EXIT
LEARN MODE
PRESS STAR KEY
TO SEND SIGNAL
ENTER MASTER
USER CODE
PRESS
TEST
ENTER AN
UNUSED SENSOR
NUMBER
SEND SIGNAL
FROM KEYPAD
START IN
TEST MODE
TEST
(760) 438-7000 • FAX (760) 438-7043
USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340
www.linearcorp.com
BY