Answering calls, Volume control and ringer setting, Making calls – Lenoxx Electronics PH-5562 User Manual
Page 6: Choosing tone or pulse dialing
IB-PH5562-WM-E-010807
Then the display will ask you to set your Area Code (FIG. 3):
While the first digit is flashing, you should:
1. Press the UP button till the first digit of your area code is
displayed (flashing).
2. Press the DELETE button to accept and go to the next digit.
3. Repeat steps 1 and 2 above to set the 2nd and 3rd digits of
your area code.
You do not have to set up the Time and Date because the
telephone company will automatically update this with
your Caller ID when your phone rings (twice or more). To
get back to the standby mode (for dialing), press the DELETE
button repeatedly until the normal display shows.
Press UP & DELETE to set
Press UP & DELETE to set
Press UP & DELETE to set
After setting the LCD contrast, language, area code, time & date, you can adjust the
display to the proper position so that you can easy read the information in the display.
AREA CODE EXAMPLE: 718
ANSWERING CALLS
1. After the phone rings, the INCOMING CALL indicator will flash simultaneously, pick up
the handset or press the SPEAKERPHONE button.
2. To end the call, replace the handset on the base or press the SPEAKERPHONE button again.
VOLUME CONTROL AND RINGER SETTING
Slide the HANDSET VOLUME control (LOUD or NORMAL).
Adjust the handset volume
Adjust the ringer level
OFF - no ringing on incoming calls.
Set RINGER HI/LO/OFF switch (on the rear of the phone).
HI - loud rings on incoming calls.
LO - lower rings on incoming calls.
MAKING CALLS
1. Pick up the handset or press the SPEAKERPHONE button to get a dial tone.
2. Dial your call.
3. To end the call, replace the handset on the base or press the SPEAKERPHONE button again.
Adjust the speakerphone
volume
Slide the SPEAKERPHONE VOLUME control (on the right
side of the phone).
5
CHOOSING TONE OR PULSE DIALING
Select the type of dialing that your telephone system requires by setting the TONE/PULSE
switch (on the rear of the telephone).
TONE - The set will operate using tone dialing.
PULSE - The set will dial using rotary dial type pulses (clicking sounds).
If you are not sure of your dialing system, make a trial call with the switch set to TONE. If the
call connects, leave the switch as it is; otherwise, set it to PULSE.
NOTE: To use caller ID service, you will probably need TONE dialing.
IB-PH5562-WM-E-010807.pmd
1/23/2007, 5:08 PM
6