LG DX0002TM - Manual (Page 24)

FLOW CHECK (DUCT CONDITION TEST)
Correct Venting
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows
or bends.
Check for blockages and lint buildup.
Make sure the ductwork is not crushed
or restricted.
I N S TA L L AT I O N I N S T RU C T I O N S I N S TA L L AT I O N I N S T RU C T I O N S
Your dryer features FlowSense ™ , an innovative sensing system that automatically detects
blockages and restrictions in dryer ductwork. Keeping ductwork clean of lint buildup and
free of restrictions allows clothes to dry faster and reduces energy use.
NOTE: When the dryer is fi rst installed, this test should be performed to alert you to any
existing problems with the exhaust duct in your home. However, since the test performed
during normal operation provides more accurate information on the condition of the
exhaust duct than does the installation test, the number of bars displayed during the two
tests may not be the same.
To activate the fl ow check (Duct condition test) :
NOTE: Dryer heating test must be performed before proceeding. Then perform the duct
condition test below:
If no bars are shown in
the display, the ductwork
is free from blockages
or restrictions.
If all bars are lit, the
dryer ductwork has a
blockage that needs to
be removed immediately.
IMPORTANT: Do NOT interrupt the test cycle!
THE DUCTWORK IS FREE
FROM BLOCKAGES OR
RESTRICTIONS.
COMPLETED FLOW CHECK
THE DUCTWORK HAS
A BLOCKAGE THAT NEEDS
TO BE REMOVED
IMMEDIATELY.
NEED FLOW CHECK
1
5
CUSTOM PGM
*PGM SAVE
OPTION
*LANGUAGE
FLOW CHECK
THIS TEST CHECKS THE CONDITION
OF THE EXHAUST DUCT AT THE TIME
OF INSTALLATION
HIGH
0:02 EST. TIME
REMAINING
FLOW CHECK
0:02 EST. TIME
REMAINING
HIGH
After pressing the POWER ON/OFF, turn the cycle
knob.
2 When pressing the OPTION button, OFF will be
displayed.
3 When pressing CUSTOM PGM, OFF will be
change to ON.
ON I
FLOW CHECK
4
After 3 seconds, or
by pressing the EXIT
button, the display
will show the FLOW
CHECK start screen.
Press START/PAUSE. The dryer
will run for approximately 2
minutes to test
for blockages
or restrictions
to air fl ow in the
ductwork.
24