Selecting a startup device, Selecting a temporary startup device – Lenovo 3658 User Manual
Page 59
To set the SATA 1, do the following:
1.
Start the Setup Utility program (see “Starting the Setup Utility program” on
page 49).
2.
From the Setup Utility program menu, select Devices → SATA Drives Setup →
SATA 1
and press Enter.
3.
Select 32 Bit Data Transfer.
4.
Select the desired settings and press Enter.
5.
Return to the Setup Utility program menu and select Exit → Save Changes and
Exit
.
Note:
If you do not want to save the settings, select Discard Changes or
Discard Changes and Exit
.
To set the OnBoard Floppy Controller, do the following:
1.
Start the Setup Utility program (see “Starting the Setup Utility program” on
page 49).
2.
From the Setup Utility program menu, select Devices → Floppy Drive Setup →
OnBoard Floppy Controller
.
3.
Select the desired settings and press Enter.
4.
Return to the Setup Utility program menu and select Exit → Save Changes and
Exit
.
Note:
If you do not want to save the settings, select Discard Changes or
Discard Changes and Exit
.
Selecting a startup device
If your computer does not start up from a device such as the CD-ROM, diskette, or
hard disk drive as expected, use one of the following procedures to select a startup
device.
Selecting a temporary startup device
Use this procedure to start up from any startup device.
Note:
Not all CDs, hard disk drives, and diskettes are bootable.
1.
Turn off your computer.
2.
Press and hold the F12 key, and then turn on the computer. When the Startup
Device Menu appears, release the F12 key.
Note:
If you are using a USB keyboard and the Startup Device Menu does not
display using this method, repeatedly press and release the F12 key
rather than leaving it pressed when turning on the computer.
3.
Select the desired startup device from the Startup Device Menu and press Enter
to begin.
Note:
Selecting a startup device from the Startup Device menu does not
permanently change the startup sequence.
Chapter 4. Using the Setup Utility
51