LEICA 2 - Manual (Page 7)

7 Getting started with new equipment GPS Equipment User Manual -2.0.0en
Getting started with new equipment
Receiver Hardware
The software contains a comprehen-
sive Online Help System. This Help
System is intended to replace the
function of a printed manual. If
required you may print out the entire
help for use as a hard copy reference
manual.
As a first step in getting familiar with
the software read the booklet
Getting
Started with SKI-Pro delivered with
the SKI-Pro software package.
SKI-Pro (SKI-Pro-L1) post-processing software
In most cases, the software will be
installed by the local Leica
Geosystems representative and a
short introductory course will be
given.
Should this not be the case, install
the software as follows:
1. Insert the CD-ROM into the CD
drive of your PC.
2. Select Install SKI-Pro from the
menu.
3. Follow the instructions given by the
installation shield.
In most cases, a short introduction in
the use of the Receiverand Terminal
will be provided by the local Leica
Geosystems representative. If this is
not the case proceed as outlined in
the following sections.
Alternatively refer to the Technical
Reference PDF-manual available on
the SKI-Pro Installation CD.