Land Pride AT2572 - Manual (Page 20)

18
Section 4: Maintenance and Lubrication
FD2560, FD2572, AT2560 & AT2572 Grooming Mower, 3-spindle 310-148M 8/08/12
Land Pride
Table of Contents
Lubrication
!
CAUTION
For Safety reasons, each lubrication operation must be
performed with the tractor’s PTO disengaged, the mower
lowered completely, tractor engine shut off and ignition key
removed.
Service Daily
1. Grease the PTO u-joints.
2. Wheel support bushings.
3. Wheel bushing.
4. Bearing in blade spindle hubs.
PTO U-Joint
Coat PTO u-joint with grease every 8 hours of operation
Type of Lubrication: Multipurpose
Quantity = Coat Generously
50 Multi-purpose
spray lube Multi-purpose
grease lube Intervals in hours
at which lubrication
is required
Lubrication
Legend
Multi-purpose
oil lube
8
Hours
Service Every 50 Hours Of Operation:
1. With the mower on level ground, check the oil level in
the gearbox by removing the plug in the side of the
box. The oil should reach the plug hole. If oil level is
low, remove the top plug in the gearcase and fill with
SAE 90 oil until oil flows from side port of the
gearbox. Reinstall plugs and retighten.
2. Disconnect PTO shaft from the tractor and slide
apart. Clean and coat the inner tube of the PTO shaft
with a light film of grease and then reassemble.
IMPORTANT: Do not overfill! Should your gearbox
require repair, take it to your Land Pride dealer.
PTO Shaft
Disconnect PTO shaft from the tractor and slide apart.
Clean and coat the inner tube of the PTO shaft with a
light film of grease and then reassemble.
Type of Lubrication: Multipurpose
Quantity = Light Film
20
Hours
12559
12559