Controls and features – Lincoln 1999 Continental User Manual

Page 72

Advertising
background image

2. Locate the compass module
mounted at the base of mirror.

3. Turn the ignition to the ON
position.

4. Insert an appropriate diameter
rod (paperclip) into the right switch
access hole underneath the compass
module and gently press for 1 to 2
seconds until ZONE and the current
zone setting are displayed on the upper right corner of the mirror.

5. Release the switch, then slowly press it down again. Press the switch
repeatedly until the correct zone setting for your geographic location is
displayed on the upper right corner of the mirror.

6. To exit the zone setting mode, release pressure from the switch for
greater than two seconds.

Compass calibration adjustment

Perform this adjustment in an open area free from steel structures and
high voltage lines.

For optimum calibration, turn off all electrical accessories (heater/air
conditioning, wipers, etc.) and make sure all vehicle doors are shut.

1. Start the vehicle.

2. Locate the compass module
mounted on the base of mirror.

3. Insert an appropriate diameter
rod (paperclip) into the left switch
access hole underneath the compass
module.

4. Gently press the switch for 1 to 2
seconds until CAL and a direction
are displayed on the upper right
corner of the mirror. (To exit CAL before performing a compass
adjustment, turn the ignition to OFF.)

Controls and features

72

Advertising