Introduction, Safety instructions, Caution – LG RDJT52 1024X768 XGA User Manual
Page 5
DLP Personal Projector
1
INTRODUCTION
Caution
TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER –SER-
VICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL. PLEASE READ THIS USER’S GUIDE BEFORE YOU
OPERATE YOUR PROJECTOR. SAVE THIS USER’S GUIDE FOR
FUTURE REFERENCE .
Safety Instructions
1.
Read this user’s guide before you operate your projector and save it for
future reference.
2.
The lamp becomes extremely hot during operation. Allow the projector to
cool for approximately 45 minutes prior to removing the lamp assembly
for replacement. Do not operate lamps beyond the rated lamp life.
Excessive operation of lamps beyond the rated life could cause them to
explode on rare occasions.
3.
Never replace the lamp assembly or any electronic components unless
the projector is unplugged.
4.
To reduce the risk of electric shock, do not disassemble this appliance.
Take it to a qualified technician when service or repair is required.
Incorrect reassembly can cause electric shock when the appliance is
subsequently used.
5.
Do not place this product on an unstable cart, stand, or table. The
product may fall, sustaining serious damage.
6.
Do not touch the top cover when the projector is under operation.
7.
The projector must be packaged into a carry bag while moving to
another place for operation.
8.
To avoid the lamp being damaged, never turn the Main Power Switch off
in the back of the projector during operation. The normal operation
procedures are to turn the power button off, and, after a 90-second
cooling process, turn off the Main Power Switch.