Lexmark C522 - Manual (Page 107)

Restoring factory default settings
107
Administrative support
Restoring factory default settings
When first entering the printer menus from the operator panel, notice an asterisk (*) next to a value in the menus. This
asterisk indicates the factory default setting. These settings are the original printer settings. (Factory defaults may vary for
different countries and regions.)
When a new setting is selected from the operator panel, the Saved message appears. When the Saved message
disappears, an asterisk appears next to the setting to identify it as the current user default setting. These settings are active
until new ones are stored or the factory defaults are restored.
To restore the original printer factory default settings:
1 Make sure the printer is on and the Ready message appears.
2 Press to enter the menus.
3 Press until Settings appears, and then press .
4 Press until Setup Menu appears, and then press .
5 Press until Factory Defaults appears, and then press .
6 Press until Restore Now appears, and then press .
The message Restoring Factory Defaults appears, followed by the Ready message.
When Restore is selected:
• No other button actions are available on the operator panel while Restoring Factory Defaults appears.
• All downloaded resources (fonts, macros, and symbol sets) in printer memory (RAM) are deleted. (Resources
residing in flash memory or on the optional hard disk are unaffected.)
• All menu settings are returned to the factory default values, except:
– The operator panel Display Language setting in the Setup Menu.
– All settings in the Parallel Menu, Serial Menu, Network Menu, and USB Menu.
Adjusting Power Saver
To adjust the Power Saver setting in the Setup Menu:
1 Make sure the printer is on and the Ready message appears.
2 Press to enter the menus.
3 Press until Settings appears, and then press .
4 Press until Setup Menu appears, and then press .
5 Press until Power Saver . appears, and then press .
6 Press or to decrease or increase the number in the scale for the desired number of minutes, and then
press .
Minute settings available range from 1–240. The menu value Disabled is also available if Energy Conserve is
set to Disabled.
The Submitting Selection message appears.
Note: The Power Saver setting may also be adjusted by issuing a Printer Job Language (PJL) command.
For more information, see the Technical Reference available on our Lexmark Web site at
www.lexmark.com.