LaCie LaCinema Black Record - Manual (Page 26)

LaCinema Black RECORD Setting Up the LaCinema Black RECORD
User Manual page 26
3.6. STEP 6: Connect to Your Network
The LaCinema Black RECORD helps you select and configure your
home network connection. Choose to connect with an Ethernet
or wireless network and follow the steps below depending on your
choice.
3.6.1. Wireless Network Connection
The LaCinema Black RECORD has a built-in WiFi antenna. When
connecting to your network via wireless, the LaCinema Black RE-
CORD helps you select, connect with, and configure your network
connection.
Use the remote control to:
1. Go to Home menu and enter the Settings Space by pressing
the Options/Settings button ( Fig. 25 ).
2. Select the Network menu, press the Down button and se-
lect Configure Network .
3. Select Wireless Connection Mode .
4. Select your wireless network from the list.
5. Enter the password if required.
6. Select the connection method, Automatic or Manual .
✦ In automatic, network parameters will be defined auto-
matically.
✦ If you choose manual, you will asked to enter the LaCin-
ema Black RECORD’s IP address.
TECHNICAL NOTE: If network is not managed by DHCP, you
may have to enter your IP address, subnet mask, router, and DNS
addresses.
7. Once done, you will go to redirected to the Settings Space menu.
8. You can check the network by selecting Connection in the
Network menu.
For details on how to transfer files from your computer to your
LaCinema Black RECORD, see section
5.3.1. Network-Attached
Hard Disk (NAS) .
Fig. 25
NOTE: Have your network password (if you use one) and your
LaCinema Black RECORD remote control handy.
IMPORTANT NOTE: Wired (Ethernet) and Wireless (WiFi) con-
nections cannot be active at the same time.