LSI MiniHAB 44929LO - Manual (Page 54)

4-4 BIOS Features
Ver. 2.0 Copyright © 2002 by LSI Logic Corporation. All rights reserved.
attached devices). After selecting an adapter and pressing Enter , the FC
Link bus is scanned and the Adapter Properties screen appears.
On the Main menu, two selections are the Boot Adapter List and Global
Properties menus.
Boot Adapter List allows selection and ordering of boot adapters. Refer
to
Section 4.5.4, “Boot Adapter List Menu,” page 4-5 , for more detailed
information.
Global Properties allows changes to global scope settings. Refer to
Section 4.5.5, “Global Properties Menu,” page 4-6, for more detailed
information.
Only adapters with LSI Logic Control enabled can be accessed.
4.5.1 Adapter Properties Menu
The Adapter Properties menu allows you to view and modify adapter
settings. It also provides access to an adapter's device settings. To
display this menu, select a device under the Adapter field on the Main
menu and press
Enter .
4.5.2 Persistent IDs Menu
The Persistent ID screen is used simply to review the automatic mapping
between a drive WorldWide Name and its assigned logical SCSI bus and
target ID. The screen can also be used to force a drive to a specific
logical Target ID.
Selecting Add WWN at an unused location clears out the associated
WWN/DID field and allows the user to enter the first 16 characters of the
WWN. Pressing
<Enter> afterwards allows the last 16 characters to be
entered. The CU automatically adds any leading zeros, if necessary. If
an entry was put in by mistake, selecting
Erase on the appropriate line
removes the entry.
Logical ID selection defaults to be the lowest ID available. This can be
changed by using the
<+> or <-> keys to cycle the numbers. The Bus
field always defaults to 0 and cannot be changed. It is displayed in the
case where an outside utility had reserved a different number.