Safety belt extension assembly, Safety belt height adjustment, Seating and safety restraints – Lincoln 2011 MKX User Manual

Page 137

Advertising
background image

Safety belt extension assembly

If the safety belt is too short when fully extended, there is an 8 inch
(20 cm) safety belt extension assembly that can be added (part number
611C22). This assembly can be obtained from an authorized dealer.

Use only extensions manufactured by the same supplier as the safety
belt. Manufacturer identification is located at the end of the webbing on
the label. Also, use the safety belt extension only if the safety belt is too
short for you when fully extended.

WARNING: Do not use extensions to change the fit of the
shoulder belt across the torso.

Safety belt height adjustment

Your vehicle has safety belt height
adjustments at the front outboard
seating positions. Adjust the height
of the shoulder belt so the belt rests
across the middle of your shoulder.

To adjust the shoulder belt height,
pull on the center button and slide
the height adjuster up or down.
Release the button and pull down
on the height adjuster to make sure
it is locked in place.

WARNING: Position the safety belt height adjusters so that the
belt rests across the middle of your shoulder. Failure to adjust

the safety belt properly could reduce the effectiveness of the safety
belt and increase the risk of injury in a collision.

Seating and Safety Restraints

137

2011 MKX (mkx)
Owners Guide, 1st Printing
USA
(fus)

Advertising