Erasing homelink buttons, Reprogramming a single homelink button, Positive retention floor mat – Lincoln 2011 MKX User Manual

Page 83: Driver controls

Advertising
background image

Erasing HomeLink

buttons

To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer

HomeLink

௡ buttons until the

indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.

HomeLink

௡ is now in the train (or learning) mode and can be

programmed at any time beginning with Step 1 in the Programming
section.

Reprogramming a single HomeLink

button

To program a device to HomeLink

௡ using a HomeLink௡ button previously

trained, follow these steps:

1. Press and hold the desired HomeLink

௡ button. Do NOT release the

button.

2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink

௡ button, follow Step 1 in the Programming

section.

For questions or comments, contact HomeLink

௡ at www.homelink.com

or 1–800–355–3515.

POSITIVE RETENTION FLOOR MAT

WARNING: Do not install additional floor mats on top of the
factory installed floor mats as they may interfere with the

accelerator or the brake pedals.

Driver Controls

83

2011 MKX (mkx)
Owners Guide, 1st Printing
USA
(fus)

Advertising