Lowepro RTA2064 - Manual (Page 20)

18
Section 4: Maintenance and Lubrication
RTA2064, RTA2072, RTR2064 & RTR2072 Rotary Tillers 311-328M 7/03/07
Land Pride
Table of Contents
Lubrication
Driveline U-Joint (Both Ends)
Coat PTO u-joint with grease every 8 hours of operation.
Type of grease = Multi-Purpose
Quantity = Coat Generously
Driveline Shaft
Disconnect Driveline from the tractor and slide apart.
Clean and coat the inner tube of the Driveline shaft with a
light film of grease and then reassemble.
Type of grease = Multi-Purpose
Quantity = Coat Generously
20
Hours
Bearing on Right End of Rotor Shaft
Grease bearing on right end of rotor shaft until grease
starts to purge from the relief hole in the bearing mount
casting on the inside of the tiller end plate.
Type of grease = Multi-Purpose
Quantity = Coat Generously 20550
8
Hours
8
Hours
22229
22230
20 Multi-purpose
spray lube Multi-purpose
grease lube
Multi-purpose
oil lube Intervals in hours at which
lubrication is required.
Lubrication
Legend