Conventions, Exposure to radio frequency radiation, Industry canada compliance statement – Lexmark 1500 Series User Manual

Page 108

Advertising
background image

Conventions

Note: A Note identifies something that could help you.

Warning: A Warning identifies something that could damage your product hardware or software.

CAUTION: A CAUTION identifies something that could cause you harm.

CAUTION: This type of CAUTION indicates that you should not touch the marked area.

CAUTION: This type of CAUTION indicates a hot surface.

CAUTION: This type of CAUTION indicates a shock hazard.

CAUTION: This type of CAUTION indicates a tipping hazard.

Federal Communications Commission (FCC) compliance information
statement

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

The FCC Class B limits are designed to provide reasonable protection against harmful interference when the equipment is operated in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult your point of purchase or service representative for additional suggestions.

The manufacturer is not responsible for radio or television interference caused by using other than recommended cables or by
unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to
operate this equipment.

Note: To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device, use a properly
shielded and grounded cable such as Lexmark part number 1021294 for USB attach. Use of a substitute cable not properly shielded
and grounded may result in a violation of FCC regulations.

Any questions regarding this compliance information statement should be directed to:

Director of Lexmark Technology & Services
Lexmark International, Inc.
740 West New Circle Road
Lexington, KY 40550
(859) 232–3000

Exposure to radio frequency radiation

The following notice is applicable if your printer has a wireless network card installed.

The radiated output power of this device is far below the radio frequency exposure limits of the FCC and other regulatory agencies. A
minimum separation of 20 cm (8 inches) must be maintained between the antenna and any persons for this device to satisfy the RF
exposure requirements of the FCC and other regulatory agencies.

Industry Canada compliance statement

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Standard ICES-003.

108

Advertising