Lexmark 1500 Series - Manual (Page 78)

Network printer does not show up in the printer selection list during
installation
Check whether the printer is on the same wireless network as the computer
The SSID of the printer must match the SSID of the wireless network.
1 If you do not know the SSID of the network, use the following steps to obtain it before rerunning the Wireless
Setup Utility.
a Enter the IP address of your wireless access point (wireless router) into the Web address field of your
browser.
If you do not know the IP address of the wireless access point (wireless router):
1 Do one of the following:
• In Windows Vista, click Œ All Programs Œ Accessories Œ Command Prompt.
• In Windows XP, click Start Œ Programs or All Programs Œ Accessories Œ Command
Prompt.
2 Type ipconfig.
3 Press Enter.
• The “Default Gateway” entry is typically the wireless access point (wireless router).
• The IP address appears as four sets of numbers separated by periods, such as 192.168.0.100.
b Enter your user name and password when prompted.
c Click OK.
d On the main page, click Wireless or any other selection where settings are stored. The SSID will be
displayed.
e Write down the SSID, security type, and the security keys if they are shown.
Note: Make sure you copy them down exactly, including any capital letters.
2 Click Programs or All Programs ΠLexmark 1500 Series.
3 Click Wireless Setup.
Note: You may be prompted to connect the printer to the computer again using the installation cable as part of
the setup process.
4 Follow the instructions on the computer screen, including typing in the SSID of the wireless access point (wireless
router) and the security keys when prompted.
5 Store the SSID and the security keys in a safe place for future reference.
Wireless Setup Utility cannot communicate with the printer during
installation (Windows users only)
These are possible solutions for Windows users. Try one or more of the following:
Check power
If the light is not on, see “Power button is not lit” on page 63.
78