LSI SYM22801 User Manual
User’s guide
Advertising
Table of contents
Document Outline
- S14017
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con...
- This equipment has been tested and found to comply with the limits for a Class B digital device, ...
- Shielded cables for SCSI connection external to the cabinet are used in the compliance testing of...
- The LSI Logic Symbios™ SYM22801 is tested to comply with FCC standards for home or office use.
- This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipm...
- Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel ...
- This is a Class B product based on the standard of the Voluntary Control Council for Interference...
- LSI Logic Corporation North American Headquarters Milpitas, CA 408.433.8000
- Contents
- Preface
- Chapter1 Using the SYM22801 Host Adapter
- Chapter2 Installing the SYM22801 Host Adapter
- 2.1 Quick Installation Procedure
- Step 1. Ground yourself before removing this host adapter board. Remove the SYM22801 Dual Channel...
- Step 2. Switch off and unplug the system.
- Step 3. Remove the cabinet cover on your computer to access the PCI slots. Refer to the user’s ma...
- Step 4. Locate the slots for PCI plug-in board installation. Refer to the user’s manual for your ...
- Step 5. Remove the blank panel on the back of the computer aligned with the PCI slot you intend t...
- Step 6. Carefully insert the edge connector J1 of the host adapter into the PCI slot. Make sure t...
- Step 7. The bracket around the connectors J3 and J7 (see Figure2.1) should fit where the blank p...
- Step 8. If you are connecting any internal SCSI devices, plug a 68-pin connector on the end of th...
- Step 9. Connect your computer’s LED cable if desired. This is designed to drive the front panel L...
- Step 10. Replace the cabinet cover as described in the user’s manual for your computer.
- Step 11. Make all external SCSI bus connections.
- Step 12. Finally, refer to the PCI SCSI Device Management System SDMS 4.0 User’s Guide (or the gu...
- 2.2 Detailed Installation Procedure
- 2.2.1 Before You Start
- 2.2.2 Inserting the Host Adapter
- Step 1. Ground yourself before removing this host adapter board. Remove the SYM22801 Dual Channel...
- Step 2. Switch off and unplug power cords for all components in your system.
- Step 3. Remove the cabinet cover on your computer to access the PCI slots.
- Step 4. Locate the slots for PCI plug-in board installation. Refer to the user’s manual for your ...
- Step 5. Remove the blank panel on the back of the computer aligned with the PCI slot you intend t...
- Figure2.1 Hardware Connections for the SYM22801 Host Adapter
- Figure2.2 Inserting the Host Adapter
- 2.2.3 Connecting the SCSI Peripherals
- 2.2.4 Making Internal SCSI Bus Connections
- Step 1. If you are connecting an internal Wide SCSI device, plug the 68-pin connector on one end ...
- Figure2.4 Internal Wide SCSI Ribbon Cable to Host Adapter Connection
- Figure2.5 Internal SCSI Ribbon Cable to Host Adapter Connection
- Figure2.6 Internal SCSI Ribbon Cable to Internal SCSI Device Connection
- Figure2.7 Connecting Additional Internal SCSI Devices
- Figure2.8 Multiple Internal SCSI Devices Chained Together
- Figure2.9 Using Both Internal Connectors on a Channel
- Figure2.10 SCSI LED Connectors
- 2.2.5 Making External SCSI Bus Connections
- 2.3 SCSI Bus Termination
- 2.4 Setting Interrupts
- 2.5 Completing Your Installation
- Step 1. Replace the cabinet cover on your computer.
- Step 2. Plug in all power cords, and switch on power to all devices and your computer.
- Step 3. Wait for your computer to boot up.
- Step 4. To change the configuration of your host adapter, see Chapter3, Configuring the Host Ada...
- Step 5. Finally, refer to the PCI SCSI Device Management System SDMS 4.0 User’s Guide (or the gui...
- 2.1 Quick Installation Procedure
- Chapter3 Configuring the Host Adapter
- AppendixA Technical Specifications
- A.1 Physical Environment
- A.2 Electrical Characteristics
- A.3 Operational Environment
- A.3.1 The PCI Interface
- Note:
- TableA.1 PCI Connector J1 (Front)
- 1
- 22
- 43
- 2
- 23
- 44
- 3
- 24
- 45
- 4
- 25
- 46
- 5
- 26
- 47
- 6
- 27
- 48
- 7
- 28
- 49
- 8
- 29
- 50
- 9
- 30
- 51
- 10
- 31
- 52
- 11
- 32
- 53
- 12
- 33
- 54
- 13
- 34
- 55
- 14
- 35
- 56
- 15
- 36
- 57
- 16
- 37
- 58
- 17
- 38
- 59
- 18
- 39
- 60
- 19
- 40
- 61
- 20
- 41
- 62
- 21
- 42
- 1
- 22
- 43
- 2
- 23
- 44
- 3
- 24
- 45
- 4
- 25
- 46
- 5
- 26
- 47
- 6
- 27
- 48
- 7
- 28
- 49
- 8
- 29
- 50
- 9
- 30
- 51
- 10
- 31
- 52
- 11
- 32
- 53
- 12
- 33
- 54
- 13
- 34
- 55
- 14
- 35
- 56
- 15
- 36
- 57
- 16
- 37
- 58
- 17
- 38
- 59
- 18
- 39
- 60
- 19
- 40
- 61
- 20
- 41
- 62
- 21
- 42
- A.3.2 The SCSI Interface
- Note:
- TableA.3 SCSI Connectors J2/J6 and J3/J7
- 1
- 24
- 47
- 2
- 25
- 48
- 3
- 26
- 49
- 4
- 27
- 50
- 5
- 28
- 51
- 6
- 29
- 52
- 7
- 30
- 53
- 8
- 31
- 54
- 9
- 32
- 55
- 10
- 33
- 56
- 11
- 34
- 57
- 12
- 35
- 58
- 13
- 36
- 59
- 14
- 37
- 60
- 15
- 38
- 61
- 16
- 39
- 62
- 17
- 40
- 63
- 18
- 41
- 64
- 19
- 42
- 65
- 20
- 43
- 66
- 21
- 44
- 67
- 22
- 45
- 68
- 23
- 46
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 11
- 12
- 13
- 14
- 15
- 16
- 17
- 18
- 19
- 20
- 21
- 22
- 23
- 24
- 25
- 26
- 27
- 28
- 29
- 30
- 31
- 32
- 33
- 34
- 35
- 36
- 37
- 38
- 39
- 40
- 41
- 42
- 43
- 44
- 45
- 46
- 47
- 48
- 49
- 50
- A.3.3 The LED Interface
- A.3.1 The PCI Interface
- AppendixB Glossary of Terms and Abbreviations
- Address
- Asynchronous Data Transfer
- BIOS
- Bit
- Bus
- Bus Mastering
- Byte
- Chain
- CISPR
- Configuration
- CPU
- DMA
- DMA Bus Master
- Device Driver
- Differential
- Dword
- EEPROM
- EISA
- External SCSI Device
- Fast SCSI
- FCC
- File
- Firmware
- Hard Disk
- Host
- Host Adapter
- Internal SCSI Device
- IRQ
- ISA
- Kbyte
- Local Bus
- Logical Unit
- LUN
- Mbyte
- Mainboard
- Main Memory
- Motherboard
- Multi-tasking
- Multi-threading
- NVRAM
- Operating System
- Parity Checking
- PCI
- Peripheral Devices
- Pin-1 Orientation
- PIO
- Port Address
- Port Number
- Queue Tags
- RAM
- RISC Core
- ROM
- SCAM
- Scatter/Gather
- SCSI
- SCSI-2
- SCSI-3
- SCSI Bus
- SCSI Device
- SCSI ID
- SDMS
- STA
- Single-Ended SCSI
- Synchronous Data Transfer
- System BIOS
- Termination
- Ultra SCSI
- VCCI
- Virtual Memory
- VHDCI
- Wide SCSI
- Word
- Index
- A
- B
- C
- cable detection simulation 2-24
- chained connection 2-11, 2-17
- change status on next boot menu
- changing the default configuration
- channel switches
- check list
- choosing the mono/color setting 3-5
- completing the SYM22801 installation 2-28
- configuring the host adapter 3-1–3-13
- connecting the SCSI peripherals 2-6
- connectors
- D
- E
- F
- G
- H
- I
- J
- L
- M
- N
- O
- P
- Q
- R
- S
- safety characteristics A-3
- SCAM support 3-7
- scan for device at boot time 3-12
- scan for SCSI logical units 3-12
- scan order 3-8
- SCSI BIOS configuration utility
- SCSI bus connections 2-6
- SCSI bus termination
- SCSI cables
- SCSI IDs 2-25
- SCSI Interface 1-2, 1-3, A-6
- SCSI Peripherals 2-6
- setting interrupts 2-27
- Setting SCSI IDs 2-25
- signal assignments
- software
- spinup delay 3-9
- switches
- SYM22801 host adapter
- 40 MHz oscillator 1-4
- accessing peripheral devices 2-4
- active termination 1-3, A-6
- BIOS support 1-1
- board characteristics 1-2
- channel switches 1-4, 2-23
- configuring 3-13
- description 1-3
- dimensions A-1
- electrical characteristics A-2
- electromagnetic compliance A-3
- features 1-2
- installing 2-28
- LED interface A-9
- NVRAM 3-2
- PCI interface 1-3
- safety characteristics A-3
- SCSI bus termination 2-18
- SCSI interface 1-3
- SDMS software 1-1, A-3
- setting interrupts 2-27
- shielded cable connectors 2-7
- supporting Ultra SCSI protocols 1-4
- thermal, atmospheric characteristics A-3
- UL flammability rating A-3
- SYM53C876 PCI-Ultra SCSI I/O Processor chip 1-3, A- 4
- sync rate 3-11
- T
- U
- V
- Customer Feedback
- Important
- Reader’s Comments
- LSI Logic Corporation
- Corporate Headquarters
- Tel: 408.433.8000
- Fax: 408.433.8989
- NORTH AMERICA
- California
- Colorado
- Florida
- Illinois
- Kentucky
- Maryland
- Massachusetts
- Minnesota
- New Jersey
- New York
- North Carolina
- Oregon
- Texas
- Washington
- Canada
- Ontario
- Quebec
- INTERNATIONAL
- Australia
- Reptechnic Pty Ltd
- China
- LSI Logic International
- Services Inc
- Denmark
- LSI Logic Development
- Centre
- France
- LSI Logic S.A.
- Immeuble Europa
- Germany
- LSI Logic GmbH
- Hong Kong
- AVT Industrial Ltd
- India
- LogiCAD India Private Ltd
- Israel
- LSI Logic
- VLSI Development Centre
- Italy
- LSI Logic S.P.A.
- Japan
- LSI Logic K.K.
- Korea
- LSI Logic Corporation of Korea Ltd
- The Netherlands
- LSI Logic Europe Ltd
- Singapore
- LSI Logic Pte Ltd
- Sweden
- LSI Logic AB
- Switzerland
- LSI Logic Sulzer AG
- Taiwan
- LSI Logic Asia-Pacific
- Avnet-Mercuries Corporation, Ltd
- Jeilin Technology Corporation, Ltd
- Lumax International
- Corporation, Ltd
- United Kingdom
- LSI Logic Europe Ltd
- Alabama
- Alaska
- Arizona
- Arkansas
- California
- Irvine
- H. H. Tel: 714.789.4100
- W. E. Tel: 800.626.9953
- Los Angeles
- H. H. Tel: 818.594.0404
- W. E. Tel: 800.288.9953
- Sacramento
- H. H. Tel: 916.632.4500
- W. E. Tel: 800.627.9953
- San Diego
- H. H. Tel: 619.571.7540
- W. E. Tel: 800.829.9953
- San Jose
- H. H. Tel: 408.435.3500
- Santa Clara
- W. E. Tel: 800.866.9953
- Woodland Hills
- H. H. Tel: 818.594.0404
- Colorado
- Connecticut
- Delaware
- Florida
- Georgia
- Hawaii
- Idaho
- Illinois
- Indiana
- Iowa
- Kansas
- Kentucky
- Louisiana
- Maine
- Maryland
- Massachusetts
- Michigan
- Minnesota
- Mississippi
- Missouri
- Montana
- Nebraska
- Nevada
- New Hampshire
- New Jersey
- New Mexico
- New York
- North Carolina
- North Dakota
- Ohio
- Oklahoma
- Oregon
- Pennsylvania
- Rhode Island
- South Carolina
- South Dakota
- Tennessee
- Texas
- Utah
- Vermont
- Virginia
- Washington
- Wisconsin
- Wyoming