Life Fitness 9500 - Manual

M051-00K46-A008
Life Fitness 9500 Aerobic Trainer
CVA Kit Installation
Kit Includes: (1) Transformer W/Line Cord, (1) PC Communications Cable, (3) Cable Ties, (1) Console
Assembly
Step 1
Carefully tilt the Lifecycle 9500 Aerobic trainer backwards until it rests on the back of its seat.
Step 2
Carefully plug the PC COMMUNICATIONS CABLE into the bike connector housing (See Figure A). Finger tighten the
thumb screws.
Step 3
Insert the TRANSFORMER PLUG into the power receptacle
located on the connector housing. Align the TRANSFORMER
LINE CORD with the CABLE TIE CLAMP leaving a small loop in
the cord at the TRANSFORMER PLUG. Guide a REUSABLE
CABLE TIE through the the CABLE TIE CLAMP and around the
TRANSFORMER LINE CORD (Detail ‘C’). Tighten the CABLE
TIE CLAMP around the TRANSFORMER LINE CORD.
NOTE: DO NOT TRIM CABLE TIES
Step 4
Apply the two reusable cable ties to combine the TRANSFORMER LINE CORD and the PC COMMUNICATIONS
CABLE as shown in Figure A. Route the combined cables over the top of the front STABILIZER BAR. Carefully tilt the
bike back to the upright position.
WARNING!: TO PREVENT CABLE DAMAGE, THE PC COMMUNICATIONS AND TRANSFORMER CABLES MUST
BE ROUTED ON TOP OF THE FRONT STABILIZER BAR AS SHOWN IN FIGURE A.