Lprint commands (information pages), Lescapechar command – Lexmark C762 User Manual

Page 162

Advertising
background image

PJL

3-83

LPRINT Commands (Information Pages)

Use these commands to print one of the internal information pages.

@PJL testpage[<CR>]<LF>

The supported

testpage

values are listed in the following table.

For example, to print a menu settings page:

Syntax:

@PJL LPRINTMENUS[<CR>]<LF>

LESCAPECHAR Command

This command modifies the code point of the escape character for the host computer
specified by the PORT parameter. The escape character is mapped to code point
0x1B for each host interface port.

Syntax:

@PJL LESCAPECHAR CHAR=byte PORT=port [<CR>]<LF>

CHAR

parameter

The

byte

value for the CHAR parameter is the code point of the ASCII character

used for the escape character.

For example, at the factory, the printer uses 0x1B (character <Esc>) for the
escape character. If CHAR = 65 is specified with this command, the printer uses
0x41 (character ‘A’) as the escape character for the host interface port specified
via the PORT parameter.

Table 3-20: LPRINT testpage Commands

testpage Value

Description

LPRINTDIRECTORY

Prints both the flash and disk directory listings. If neither flash
memory or a disk is installed, the command is ignored.

LPRINTTESTPAGE

Prints the test page.

LPRINTMENUS

Prints the menu settings page.

LPRINTPCLFONTS

Prints the PCL font listing.

LPRINTPSFONTS

Prints the PostScript font listing.

Advertising
This manual is related to the following products: